Acrylic Filler Standard 400gr White - Mercola

STANDARD is ready mixed white acrylic masonry filler suitable for both interior and exterior use. It is suitable for smoothing and preparing surfaces prior to painting, as well as filling and coating cracks and holes on walls, ceilings, floors and doors. May be applied on plaster, concrete, brick, stones, render and wood.

ADVANTAGES

• Ready mixed formula
• Smoothens uneven surfaces
• Excellent workability, offers a tough smooth finish
• Dries fast and can be easily sanded
• Presents low shrinkage – does not crack
• Forms a non-absorbent white substrate, ready for painting
• Interior and exterior use
• Rapid and clean application

APPLICATIONS

• It is suitable for smoothing and preparing as well as filling cracks of interior and exterior walls and ceilings prior to the final coat.
• It is suitable for plaster, smooth concrete surfaces, aerated concrete blocks, plasterboards, cementboards etc.

Specifications:

• Coverage: acording to application
• Thinning: no
• Application: by knife
• Touch dry: 1 hour 20oC
• Hard dry: 3 - 4 hours 20oC
• Exterior and Interior use
• Application temperature: 10oC - 35oC
• Cleaning: with water

INSTRUCTIONS FOR USE

1. Surfaces must be dry and clean from dust, grease and loose particles and other contamination
2. For deeper cracks or joints application of water-based primer ISOCRYL DUR AQUA is necessary
3. Apply with a spatula or spreader
4. Press the filler onto the surface to a maximum depth of 9mm
5. For deep cavities apply in layers and allow each to dry (approximately 1 hour)
6. Fill hole proud to allow for sanding and finish with a wet knife
7. Once dry, sand to a smooth finish
8. The final surface may be primed and painted
9. Close lid immediately after use to prevent drying

It is advisable to perform a suitability test prior to full scale application

REMARKS

• Do not use to fill plastics or metals
• Do not apply externally when rain is imminent (within 5 hours of application)
• Do not apply at temperatures (ambient and surface) below 5oC
• Not suitable for repairs to permanently wet areas
• Do not apply in layers more than 9mm deep. For deeper holes build up in layers allowing each layer to dry before applying the next

Reference Code: 11120